CS270 Recitation 7
More LC-3 Programming

Goals

1. To extend your knowledge of LC-3 programming with a more complex algorithm.
2. To solidify your knowledge of how to use the LC-3 assembler and simulator to debug assembly code.

The Assignment

1. Make a subdirectory called R7 for the recitation; all files should reside in this subdirectory. Copy the file from R7.asm to the R7 directory, a listing of the code is shown below.

       ; Recitation 7
       ; Author: <name>
       ; Date:   <date>
       ; Email:  <email>
       ; Class:  CS270
       ; Description: Mirrors least significant byte to most significant
       ;--------------------------------------------------------------------------
       ; Begin reserved section: do not change ANYTHING in reserved section!
   
                       .ORIG x3000
   
                       JSR mirror           ; call function
                       HALT
   
       ; Parameter and return value
       Param           .BLKW 1              ; space to specify parameter
       Result          .BLKW 1              ; space to store result
   
       ; Constants
       One             .FILL #1             ; the number 1       
       Eight           .FILL #8             ; the number 8
       Mask            .FILL x00ff          ; mask top bits
   
       ; End reserved section: do not change ANYTHING in reserved section!
       ;--------------------------------------------------------------------------
       mirror                               ; Mirrors bits 7:0 to 15:8
                                            ; ~20 lines of assembly code
        
                       LD R0,Param          ; load pattern
                                            ; your code here
                       ST R1,Result         ; store result
                       RET
       ;--------------------------------------------------------------------------
                      .END
       

2. Use the LC-3 assembler to transform your assembly code into object code that can run on the LC-3 simulator:

   ~cs270/lc3tools/lc3as R7.asm

3. Load the LC-3 simulator. The TA will help you step through an invocation of one of the LC-3 subroutines:

   ~cs270/lc3tools/lc3sim-tk &

4. Implement the mirror subroutine, using the following algorithm. It’s a poor algorithm. Resist the urge to improve it.
   • Load the parameter into register 0
   • Make a copy of register 0 to register 1, which stores the result.
   • Load Mask into register 2
   • Use the mask to clear bits 15:8 in the result
   • Initialize register 2 to 1, this is the source mask
   • Initialize register 3 to 1, this is the destination mask
   • Initialize register 4 to 8, this is the counter
   • Write a loop to shift register 3 left by eight bits, by adding it to itself
   • Initialize register 4 to 8, again.
   • Write a loop that:
     1. checks if the bit in the source mask is set in the parameter. This is very similar to the operation you used in the RightShift route in P5 to examine a value using a mask.
     2. if so, adds the bit in the destination mask to the result
     3. then shifts the source mask left by adding it to itself
     4. then shifts the destination mask left by adding it to itself
     5. and finally decrements the counter until it reaches zero
   • Store the result into the Result memory location and return
5. Test the mirror subroutine in the simulator using Param = 0x1234. The answer in Result should be 0x3434.